[asterisk-users] Tips for installing and configuring Digum cards

Mitch Claborn
2012-10-11T14:34:24Z

In case the moderator doesn't approve my post with the attachment, below
is a quick and dirty transcription of the order form.

Customer connecting equipment: CSU/DSU
Circuit: DS1
Line coding: B8ZS
Framing: ESF
Jack type: RJ48X / Smartjack (will that fit into the Digum card?)
ISDN protocol: NI2
Primary D-channel assignment: 24
FAS
Incoming port selection: Ascending sequential 1-24
Indound real-time ANI delivery? yes, 10 digits


Does anyone see any red flags or things to watch out for in these specs?
  Anyone configured a similar line that is willing to share your config
files?

I'm traveling for the next several hours, so apologies if I don't
respond right away.

Mitch

On 10/10/2012 10:34 AM, Mitch Claborn wrote:
> Tomorrow evening I'll be at a customer site installing 2 Digum cards -
a
> 4 port analog and 2 port T1.  I'd appreciate any tips, resources and
> links that you have that might help if we run into trouble.  It will, of
> course, be fairly late at night and relatively high pressure to get it
> working, so I'd like to collect as much information in advance as I
can.
>
> I was able to install and test the analog card in my lab, so not too
> worried about that.
> I installed the T1 card in the lab and got the system and Asterisk to
> recognize it, but had no T1 to test with.
>