[Asterisk-Users] TE405P V2 changes?

Kib Eki
Fri, 12 Aug 2005 00:43:14 -0000

Hi,
we also got one V2 TE405P card. It works fine now. At the moment we use for
bridging the Pri to our old PBX.
You must use zaptel, libri and asterisk v 1.0.8 or higher. We use 1.0.9 at the
moment.
zaptel:
after make; make install i also executed make config. This copies the correct
startup script to /etc/init.d/zaptel. Without this it also didn't worked for
me.



Master Abi wrote:
> Hi
>
> I got the 2nd Gen firmware upgraded on the TE405P.  I recompiled after
> putting in the upgraded board but did not change any conf, but the spans
> become active but will not come up.
>
> I guess I am missing something or are the any changes to the
> zaptel/libpri software that is required. I cannot find any info about
> this or does this new firmware only work with latest CVS. I am using
> 1.0.9 with 2.6.12 kernel
>
> Zapata Telephony Interface Registered on major 196
> Found TE4XXP at base address fdfff000, remapped to f8928000
> TE4XXP version c01a0164, burst ON, slip debug: OFF
> TE4XXP running with work queues.
> FALC version: 00000005, Board ID: 00
> Reg 0: 0x364e9400
> Reg 1: 0x364e9000
> Reg 2: 0xffffffff
> Reg 3: 0x00000000
> Reg 4: 0x00000001
> Reg 5: 0x00000000
> Reg 6: 0xc01a0164
> Reg 7: 0x00001f00
> Reg 8: 0x00000000
> Reg 9: 0x00ff0000
> Reg 10: 0x00000000
> TE4XXP: Launching card: 0
> TE4XXP: Setting up global serial parameters
> Found a Wildcard: Wildcard TE405P (2nd Gen)
> eth0: link up, 10Mbps, half-duplex, lpa 0x0000
> About to enter spanconfig!
> Done with spanconfig!
> About to enter spanconfig!
> Done with spanconfig!
> Unassigning channel 0/1!
> Unassigning channel 0/2!
> Unassigning channel 0/3!
> Unassigning channel 0/4!
> Unassigning channel 0/5!
> Unassigning channel 0/6!
> Unassigning channel 0/7!
> Unassigning channel 0/8!
> Unassigning channel 0/9!
> Unassigning channel 0/10!
> Unassigning channel 0/11!
> Unassigning channel 0/12!
> Unassigning channel 0/13!
> Unassigning channel 0/14!
> Unassigning channel 0/15!
> Unassigning channel 0/16!
> Unassigning channel 0/17!
> Unassigning channel 0/18!
> etc...
>
> This was working for 10 months before the upgrade.
>
> Master
>
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users@lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>   http://lists.digium.com/mailman/listinfo/asterisk-users
>
>