[Asterisk-Users] bri error

David Masure
Fri, 29 Apr 2005 03:19:58 -0000

The problem may then originate from the NT of your telco ....


-----Message d'origine-----
De : Altus Snyman [mailto:altus@stormcorp.co.za]
Envoy? : vendredi 29 avril 2005 12:21
? : David Masure
Cc : Asterisk Users Mailing List - Non-Commercial Discussion
Objet : RE: [Asterisk-Users] bri error


if I do a zttool it shows TE mode

On Fri, 2005-04-29 at 12:14, David Masure wrote:
> Did you put your card in TE mode ?
>
> To it seems you have configured your card to act like a NT but if you
> are connected to bri telco lines, it should be in TE mode
>
> check in your zaptel.conf : bri te signalling
>
> regards
>
> David
>
>
>
> -----Message d'origine-----
> De : Altus Snyman [mailto:altus@stormcorp.co.za]
> Envoy? : vendredi 29 avril 2005 12:08
> ? : Asterisk Users Mailing List - Non-Commercial Discussion
> Objet : [Asterisk-Users] bri error
>
>
> Good day all
> This is a error that keeps on popping up in my /var/log/messages when
I
> get incoming or outgoing calls on my bri card connected to 4 telco
isdn
> units?It is a junghanns 4 port card with the latest version of the
> drivers and latest asterisk
> Apr 29 11:37:39 ccv kernel: qozap: BAD CRC for hdlc frame on card 1
> (cardID 0) S/T port 1
> Apr 29 11:37:39 ccv kernel: qozap: check the 100 Ohm termination for
> this span!
> Apr 29 11:45:25 ccv kernel: zaptel Disabled echo canceller because of
> tone (rx) on channel 1
>
> Please help and advice?
>
> _______________________________________________
> Asterisk-Users mailing list
> Asterisk-Users@lists.digium.com
> http://lists.digium.com/mailman/listinfo/asterisk-users
> To UNSUBSCRIBE or update options visit:
>    http://lists.digium.com/mailman/listinfo/asterisk-users
>