[Asterisk-Users] Error when loading wcfxo

Marc Spiegelman
Tue, 04 May 2004 11:17:36 -0000

I found similar posts regarding this error but none that answered my
question.



My zaptel.conf reads:



fxsks=1-2

fxoks=3

loadzone=us

defaultzone=us



and /proc/interrupts:

           CPU0

  0:    5542402    IO-APIC-edge  timer

  1:          2    IO-APIC-edge  keyboard

  2:          0          XT-PIC  cascade

  8:          3    IO-APIC-edge  rtc

 14:      72582    IO-APIC-edge  ide0

 16:      81197   IO-APIC-level  eth0

 17:   54874555   IO-APIC-level  wcfxo

 20:   54874082   IO-APIC-level  wcfxo

 22:   54174464   IO-APIC-level  wctdm

NMI:          0

LOC:    5542842

ERR:          0

MIS:          0







When I run modprobe wcfxo I get the following error:



ZT_CHANCONFIG failed on channel 3: No such device or address (6)

/lib/modules/2.4.26/misc/wcfxo.o: post-install wcfxo failed

/lib/modules/2.4.26/misc/wcfxo.o: insmod wcfxo failed





After running modprobe wcfxs, the asterisk machine runs fine and ztcfg
doesn't complain.



I tried moving cards to different slots but the error didn't go away.

If I remark out the fxoks=3 line the error goes away

If I reverse the load order in zaptel.conf and fire up the zaptel
modules (in reverse), I stop getting the error.



So my question is why does the wcfxo try to fire up my TDM400 and is
this error a problem?



-------------- next part --------------
An HTML attachment was scrubbed...