On Sat, Nov 30, 2019 at 03:59:54PM +0000, Richard M
wrote:> Hello
> I found under networking in the Domain XML 'Multcast tunnel'.
> My question is does anyone know what is the intended use of multicast
> tunnel networking?What are the potential pitfalls of using such a
> configuration other than what's highlighted in the domain xml. eg:
> can it suffer from throughput issues? Can the tunnel be accessed from
> outside Libvirt?
> I'm struggling to find any information about it. If anyone has any
> information about it, Or where I can obtain such information it would
> be appreciated.
This is something that has been supported by QEMU forever, but I think
it is fair to say it is rarely used.
The main use case would be setting up network communication between
a group in QEMU instances (possibly across hosts) in a case where you
don't have access to any better technology such as tap device + bridging.
eg if you are an unprivileged user & cannot get root.
I doubt performance is going to be anything special. There's also
no meaningful security - any user or process or host can send &
receive on the same multicast address.
Regards,
Daniel
--
|: https://berrange.com -o- https://www.flickr.com/photos/dberrange :|
|: https://libvirt.org -o- https://fstop138.berrange.com :|
|: https://entangle-photo.org -o- https://www.instagram.com/dberrange :|