search for: shmanci

Hello, I'm writing because we have problems with an asterisk installation (Trixbox ver. 1.2.3). We have a customer which is receiving a lot o telephony traffic (more or less 1 call/2 min.); we are using a TDM400 board, with 3 PSTN lines configured and we have two big issues: - Calls are dropped during conversation (I have a busycount=8 from the initial value that was 4) -

I recently received a GoIP-32 for a client project -- primarily outbound calling. How should a GoIP be configured for Asterisk? No fancy shmancy Elastix or FPBX GUI -- just using the configuration files. Single Server Mode, Config By Line, and Trunk Gateway Mode all seem likely suspects. How did you configure your GoIP and why? What do your relevant sip.conf section(s) look like? What does

Hi All, I am looking at ZFS and I get that they call it RAIDZ which is similar to RAID 5, but what about RAID 10? Isn''t a RAID 10 setup better for data protection? So if I have 8 x 1.5tb drives, wouldn''t I: - mirror drive 1 and 5 - mirror drive 2 and 6 - mirror drive 3 and 7 - mirror drive 4 and 8 Then stripe 1,2,3,4 Then stripe 5,6,7,8 How does one do this with ZFS?